Triac at work video

[Triac whizz]

Just for giggles I've uploaded a video of my Triac hammering a 18mm U drill through ali at 3500rpm and 200mm/min, the vid goes on and shows the whole job, there's no interval for popcorn & ice cream I'm afraid

https://video.google.co.uk/videoplay?doc ... 7361361204

broadband recomended

[davidimurray]

Nice video.

Is that a stepper or a servo machine? Original controls or a retrofit?

When I get a min will post some vids of the starturn at work.

Cheers

Dave

[Triac whizz]

Fanuc controls - out of the box as it left Denfords, give or take a few parameter changes

[Denford Admin]

Nice - what is it ?

btw - no guards on your machine ?

[Triac whizz]

It's a bearing block see viewtopic.php?t=342 the thingys on the right

Guarding? It's all there - for what its worth but it was down for the video and I can't put it right up when I have a vice on the table - and wellies are obligatory when using suds! Is there something missing then? perhaps a cagoule?