VersaLaser Advanced Driver

nero · Thu 24 Aug , 2006 8:18 am

Is there a manual for the

VersaLaser Advanced Driver

Thu 24 Aug , 2006 8:58 am

There is the installation guide here:

https://www.denfordata.com/downloads/for ... driver.doc

Looks a bit in-depth - use at your own risk !

If I find anything else, I'll post it up

casiopedia · Wed 10 Oct , 2007 23:57 pm

Do you have the Advance Program Install? Where can I download it.?

Steve · Thu 11 Oct , 2007 11:13 am

Hi,

Where are you located and where did you purchase your laser?

Steve

casiopedia · Thu 11 Oct , 2007 15:19 pm

I really don't know where it was purchased, I'm supposing that directrly from Universal Systems because we had replaced some parts with them in the past, but we have 2 laser machines, I'm Located in El Paso, TX, We have 1 Universal M-360 and a VersaLaser VL200 and I'm looking for the Versalaser Advanced Driver for my Versalaser.

Steve · Thu 11 Oct , 2007 15:48 pm

I am not sure if we can distribute the advanced driver from here.

The ULS staff monitor our forum so hopefully they will reply and tell you how you can get hold of this.

I will make a request that they respond.

ULS Service · Fri 12 Oct , 2007 10:50 am

Hello casiopedia,

The advanced driver is not for free and you have to attend a special training in Scottsdale at ULS Inc. before you allowed to get it.
Please get in contact with your sales person and let him know your machine serial numbers and also your request.

Thank you for your understanding.
best regards

Information