CNC Apprentice
Thanks for the atatchments guys its much appreciated.
After doing some searching last night it would appear that the control boards are still made for these and i also found a place that repairs them for £168 so alls not lost if it turns out to be the drive card.
Some how i feel a lot better now
After doing some searching last night it would appear that the control boards are still made for these and i also found a place that repairs them for £168 so alls not lost if it turns out to be the drive card.
Some how i feel a lot better now
Site Admin
We should be able to supply a new sprint drive which is still used, from what I can see, (but don't quote me on this) they are just under £200
It's worth emailing sales
denford 
co uk
It's worth emailing sales
denford co uk
CNC Apprentice
Denford Admin wrote:We should be able to supply a new sprint drive which is still used, from what I can see, (but don't quote me on this) they are just under £200
It's worth emailing sales
Will these work as a direct replacment to what i already have and is there much setting up to be done at all??
CNC Guru
You would need a tacho to read the spindle speed when setting it up but the rest is straightforward.
If you have the current drive repaired check that the pots are set to the same position as they were when you fitt it back in.
If you have the current drive repaired check that the pots are set to the same position as they were when you fitt it back in.
CNC Guru
BI00307H Sprint 1200 sells for £198 and we have 4 in stock.
CNC Guru
Does it not need to be a Sprint 1200i with it being on a Fanuc
Site Admin
Don't our suppliers still do the Lynx by the way ?