Hi All
We use a newturn 270 and VR turning v 1.22..... how do I set 'X' for internal threading and boring????
Snowand
Site Admin
Setting the offset is just the same as for external diameters...
You'll have to drill the bore first with at least a 10mm drill (or use tube)
Then manually run the boring bar down the hole, pull out keeping X at the same height
Measure the internal diameter with verniers for example, and set the tool offset to the diameter reading (eg 18.678mm)
You'll have to drill the bore first with at least a 10mm drill (or use tube)
Then manually run the boring bar down the hole, pull out keeping X at the same height
Measure the internal diameter with verniers for example, and set the tool offset to the diameter reading (eg 18.678mm)
Attachments:
- MeasureBore.jpg (97.23 KiB) Viewed 18189 times