URGENT help needed please.Triac Fauc ATC tool change problem

[Brycam]

Hi there,
Can anyone give me some advice, I have a job deadline of tomorrow and when switching on my machine this morning the OM control tool changer is half a pocket out.
I HAVE FOLLOWED THE M27/28 REFERENCING INSTRUCTIONS BUT IT HASNT WORKED, SO IF ANYONE CAN HELP I WOULD BE VERY GRATEFUL.

M34 not recognised for half turn

Cheers
Bry

[Denford Admin]

If the mcodes aren't working for half turn then the best thing might be to power it off, disconnect motor and turn it by hand...
You may also be able to spin the motor pulley by hand with the power off...