I have purchased a Triac VMC I can run a program dripfeed if it is on the internal hard disk and I have managed to send and recieve programs to and from another pc via a RS232 cable. Is it possible to run a program dripfeed from the external PC? If so how do I get the mill in dripfeed mode to accept/run the program?
Triac VMC
Serial no. 50809A
Year 1995
Software Fanuc 2.88
Many thanks in advance
Nick
Site Admin
This guy has previously had drip feed working on (I'm guessing) a similar machine:
viewtopic.php?f=4&t=1107
Maybe you could PM (Private message) him if it's the same setup as yours.
This other post may also help:
viewtopic.php?t=756
viewtopic.php?f=4&t=1107
Maybe you could PM (Private message) him if it's the same setup as yours.
This other post may also help:
viewtopic.php?t=756