I have a novamill minus the lid and the part of the interlock that fits in the red socket on the side (i.e. the bit fitted to the lid).
Has anyone got a lid with the intelock fitted or just the interlock so I could make my own lid ?
Thanks.
Site Admin
Can you post a picture of the hole in the red guard interlock ? There have been some variations over the years, but we might well have some spare "plungers" here
CNC Expert
Not sure if I have uploaded the pictures right, but here goes !!Denford Admin wrote:Can you post a picture of the hole in the red guard interlock ? There have been some variations over the years, but we might well have some spare "plungers" here
Attachments:
- DSCF2372.JPG (151.8 KiB) Viewed 7247 times
- DSCF2374.JPG (48.94 KiB) Viewed 7247 times
Site Admin
Bit confused now - do you want another plunger? Or the red guard interlock box which the plunger goes into ?
CNC Expert
Denford Admin wrote:Bit confused now - do you want another plunger? Or the red guard interlock box which the plunger goes into ?
I need the item in the picture.
I have a novamill and novaturn which I got from a nearby school. The mill was minus it's acrylic screen, and the key looking part that is fitted to it, i.e. the part in the picture. I now have to key from the lathe loose, so I can operate the mill by using the key from the lathe, but when I make a screen for the mill, I would like to fit a proper key to it, as I am safety conscious. I hope I have explained it better this time. Thanks.
Site Admin
Ok I've found one - if you donate a fiver via paypal on the front page we'll post it on...
CNC Expert
I have now done that. Thank you very much, and thank you for taking the time to find it for me.Denford Admin wrote:Ok I've found one - if you donate a fiver via paypal on the front page we'll post it on...
Site Admin
No problem - just hope nobody else wants one as its the only one in the building 