User avatar
CNC Guru
CNC Guru
EPROM Chip identification
Customer writes .........

I have just bought a Novamill, vintage 1999, s/n 90804F from a school to use as an introduction to CNC milling in my hobby of model making. It appears to be complete and in good condition but minus PC and software. The chip fitted to the Denstep board is marked "DenMINT V2.0.b10/s/B19-JD5" and a second chip marked "ESMINT 3.28 V1.6H/S-JD5" was also with the machine.
User avatar
CNC Guru
CNC Guru
Re: EPROM Chip identification
"DenMINT V2.0.b10/s/B19-JD5" - The early Version for running VR Milling Ver2 superceded by Ver 2.1b6
"ESMINT 3.28 V1.6H/S-JD5" - For running Denford DOS software
Re: EPROM Chip identification
I have faulty baldor D281 optimised control card for a triac P. C. (denford). The firmware is ESMINT 3.28 V1.6H/S - JD5.

I have attached an image of the motion controller card. Please, we can we get a used/replacement/used one? Thank you.
Attachments:
e12.pdf
Motion controller card (view 2)
(156.97 KiB) Downloaded 788 times
e11.pdf
Motion controller card (view 1)
(143.75 KiB) Downloaded 788 times
Post Reply

Information

Moderators

Mr Magoo, Martin, Steve