Does anyone know who is offering the conversion service for Starturn5 in Ashton-U-Lyne?
Yes! I'd like to use Mach3 with my Starturn5. I had seen on your board ( I could be mistaken) a message from someone in Ashtun U Lyne who was offering to convert these machines.
I'd be grateful if anyone offering this service would get in touch.
Many thanks.
Meanwhile I'd like to get it running with the present controller but I'm finding the software a bit of a jungle.
What software?
What platform?
How to unstall?
If anyone has put together a simple install routing to get the Starturn5 running I'd like very much to hear from them.
I'd be grateful if anyone offering this service would get in touch.
Many thanks.
Meanwhile I'd like to get it running with the present controller but I'm finding the software a bit of a jungle.
What software?
What platform?
How to unstall?
If anyone has put together a simple install routing to get the Starturn5 running I'd like very much to hear from them.
Site Admin
viewtopic.php?t=1096
davidimurray has done a couple of starturns converted mach, I believe
If you can find him in the membelist, there will be a list of his posts.
davidimurray has done a couple of starturns converted mach, I believe
If you can find him in the membelist, there will be a list of his posts.