CNC Expert
How do I convert the Denford Co2 Car Fixture from F1 car blanks to Dragster Blanks?
CNC Expert
Here are some photos that show how to convert the fixture.
Attachments:
- Tighten the 4 bolts keeping the V-block square to the table and side rails.
- DSC00487.JPG (138.81 KiB) Viewed 22862 times
- Use a square to align the V-block with the table.
- DSC00488.JPG (121.86 KiB) Viewed 22862 times
- Move the block to the end of the fixture and use a square to align the block with the side rails.
- DSC00489.JPG (115.6 KiB) Viewed 22862 times
- Remove the 4 bolts from the V-block.
- DSC00490.JPG (148.92 KiB) Viewed 22862 times
- Remove the F1 block assembly from the jig.
- DSC00491.JPG (117.07 KiB) Viewed 22862 times
- Loosen the straps that hold the F1 block assembly to the jig.
- DSC00492.JPG (131.81 KiB) Viewed 22862 times
CNC Expert
More photos to finish up the conversion.
There is a Word Document at the end with some Hints and Tips for using the Denford Co2 Car Fixture.
There is a Word Document at the end with some Hints and Tips for using the Denford Co2 Car Fixture.
Attachments:
- Tighten the straps to hold the Dragster assembly in th jig.
- DSC00482.JPG (137.32 KiB) Viewed 22860 times
- Tighten the clamps to hold the front of the block to the nose plate.
- DSC00483.JPG (145.7 KiB) Viewed 22860 times
- Sand or file the front of the block to fit the nose plate.
- DSC00484.JPG (152.1 KiB) Viewed 22860 times
- The front of the block must fit tight in the nose plate.
- DSC00485.JPG (137.81 KiB) Viewed 22860 times
- Remove the clamps from the top of the F1 nose plate.
- DSC00486.JPG (121.86 KiB) Viewed 22860 times
- F1 Offsets for the Denford Co2 Fixture.doc
- Hints and Tips for the Co2 Car fixture
- (33 KiB) Downloaded 1898 times