CNC Guru
WHAT IS THE MINIMUM SPEC SOMPUTER REQUIRED TO RUN VR MILLING 5?
CNC Guru
System Requirements
IBM or 100% Compatible PC
3 1/2 Inch Floppy Drive (for registration disk)
Pentium III 500Mhz
128Mb RAM
Microsoft Windows 98 and above
CD-ROM Drive
50Mb free Hard Disc space
Open GL 3D Accelerator Graphics Card with 32Mb VRAM supporting 1024x768 resolution
Single Users :
'Single User' version requires 1 x free parallel port (for security dongle)
For Machine Interface :
RS232 machine interface requires 1 x free serial port
USB (optional) machine interface requires 1 x free USB port plus Windows XP/NT/2000 operating system
IBM or 100% Compatible PC
3 1/2 Inch Floppy Drive (for registration disk)
Pentium III 500Mhz
128Mb RAM
Microsoft Windows 98 and above
CD-ROM Drive
50Mb free Hard Disc space
Open GL 3D Accelerator Graphics Card with 32Mb VRAM supporting 1024x768 resolution
Single Users :
'Single User' version requires 1 x free parallel port (for security dongle)
For Machine Interface :
RS232 machine interface requires 1 x free serial port
USB (optional) machine interface requires 1 x free USB port plus Windows XP/NT/2000 operating system
Site Admin
NB - The USB machine control aspect of the software will NOT work on 64-bit operating systems like Vista 64bit
This is because 32 bit USB device drivers are not supported on Vista 64.
However, there is a possibility that RS232 machine communication would work but we have not tested this yet.
This is because 32 bit USB device drivers are not supported on Vista 64.
However, there is a possibility that RS232 machine communication would work but we have not tested this yet.