Compact 1000 - F1/Dragster Fixture - Blank Moving

[Benny]

Compact 1000 - New Style F1/Dragster Fixture mounted on table.
I notice that the dragster blank seems to be moving around too much in the fixture on the tapered end. I tried really pushing things together when I set it up, but it is still moving about 4-5 mm when machining. Any ideas?

[Benny]

You need to use the same small hold downs that you use with the F1 attachment and you should be good to go!

[boots]

Attached are photos of the nose block using the black clamps to hold an F1 balsa block and a Dragster balsa block.