I just inherited 12 Denfords. All pretty much brand new, and I could use some help. Firstly can anyone tell me how to update my Micromill Integrator. I have the the @ 97 software and i would like to get it to a more 3dish view. All the mills are about 10 years old and they have allthe original software.
Any help would be appreciated.
Site Admin
I'm guessing its the DOS software you have ?
I'm not sure what control was fitted to a Micro machine in 1997, but guess it would be a Smartstep ?
Can you take a look at this PDF
https://www.denfordata.com/projectimages ... _guide.pdf
It should answer your question, and confirm to us what control(s) you have.
I'm not sure what control was fitted to a Micro machine in 1997, but guess it would be a Smartstep ?
Can you take a look at this PDF
https://www.denfordata.com/projectimages ... _guide.pdf
It should answer your question, and confirm to us what control(s) you have.