Easiturn control cabinet removal

[EVguru]

I'm trying to take the control cabinet off the top of my Easiturn. It uses the same kind of mounting collar as my Easimill, with the control cabinet sandwiched between the collar flange and the actual lathe cabinet. There aren't any set screws holding the collar into the lathe, at least none I can even get a finger to through the small wiring access hatch.

Has anyone taken one off?

[Martin]

It`s a while since have taken one off.

From what I remember there is either one or two grub screws on the collar the control sits in underneath the control.