TDS 1 LS-Leadscrew drawings

[De-El]

Good day,

I posted this over in the downloads section.
viewtopic.php?f=15&t=5707
Just linking to it from here hoping to find the info I am after.

Regards
D

[rpwilson]

ML 105 402 and 403? What parts are they?

Richard

[De-El]

Richard

ML 105/402 is the 'English'-thread Leadscrew
ML 105/402C is the Metric-thread Leadscrew

ML 105/403 is the Leadscrew collar

Regards
D

[Andy B]

Leadscrew drawings now uploaded in this thread - viewtopic.php?f=50&t=2941&p=22970#p22970


Collar drawing was already uploaded in this pack of scans - https://www.denfordata.com/downloads/for ... 0scans.pdf

If anyone wants to produce a list of the drawings in each of the packs already uploaded, please do so and send it to me so that I can add to the original post and make searching easier.

Andy

Edited to add extra info.

[rpwilson]

I've got a scanned copy of ML105 400 which is a general arrangement of the leadscrew, the collar and the support brackets if thats any help, at least it show how they fit together. Is it the metric leadscrew or the imperial one you need? They will be the same except that one will have an 8TPI thread and the other will have a 3mm pitch thread.
At times like this, Ebay is your friend for parts.

Richard

[Andy B]

Just uploaded ML105/400 too - same post as the leadscrews

Andy

[De-El]

Leadscrew drawings now uploaded in this thread - viewtopic.php?f=50&t=2941&p=22970#p22970


Collar drawing was already uploaded in this pack of scans - https://www.denfordata.com/downloads/for ... 0scans.pdf

If anyone wants to produce a list of the drawings in each of the packs already uploaded, please do so and send it to me so that I can add to the original post and make searching easier.

Andy

Edited to add extra info.

Thank you so much Andy.
This helps me a lot.

I did go through the pack of scans already, unfortunately ML105/403 is not in there. But it looks like a very simple part I can derive from the arrangement drawing, ML105/400, and make my own if the original drawing is not available. I just want to try and stick as close to the original as possible were I can.

Regards
D

[Andy B]

I did go through the pack of scans already, unfortunately ML105/403 is not in there.

Yes it is - on page 23.
It must have been out of sequence when the pile was scanned - between ML105/306 and ML105/307.

Andy

[De-El]

I did go through the pack of scans already, unfortunately ML105/403 is not in there.

Yes it is - on page 23.
It must have been out of sequence when the pile was scanned - between ML105/306 and ML105/307.

Andy

Oops, sorry I didn't notice that, I see it is there yes.

Thank you.
D