Hello Everybody,
I started a project fitting an old Easimill 3 with new controls. For now I'm concentrating on the control cabinet and would like to keep using the old Combivert 53 inverter.
The new controls (Mach3/ CSMIO/IP-M) come with an analogue 0-10V output, meant to control an inverter. I assumed I would be able to use this output once the 0V/GND of the controller and the inverter are connected.
However, in the forum it was suggested that this isn't possible (viewtopic.php?f=34&t=3236&p=11678&hilit ... ert#p11678).
Has this ever been tried or does anybody even have an actual manual for this inverter?
Kind regards,
Axel
Analogue command value for KEB Combivert inverter
Moderators: Martin, Steve, Mr Magoo
-
- Posts: 1
- Joined: Thu 21 Jun , 2018 9:14 am
- Hardware/Software: currently working on
Denford Easimill 3 originally with PNC3 controls, Digiplan CD20 drivers and KEB Combivert spindle drive
Controls to be replaced by Mach3, CS-Labs CSMIO-IP-M controller and Leadshine EM806 stepper drivers