Rotating tool turret command within program.

triac · Post by **triac** » Sun 17 Dec , 2017 1:35 am

Help please.

Using the original DOS editing program on an Orac how can I tell the tool turret to rotate within a program ?

Marcus

Steve · Post by **Steve** » Sun 24 Dec , 2017 16:46 pm

The tool should change if you program an M6 followed by the toolmumber. If the machine thinks it’s a manual tool changer then it will ask you to change tool. If set as an auto toolchanger then it will auto index.

triac · Post by **triac** » Tue 26 Dec , 2017 11:20 am

Thanks for the info Steve, will pass on the details.

Emgee

Information