Easimill stepper motors?

[plan_b_racing]

Hi all,
I was wondering if someone could help me. I recently acquired a Denford Easimill 1984 model which is missing all its stepper motors. I was wondering if someone could tell me what frame size the stepper motors are i.e. Nema 34 or 42? Also what holding torque they are? I have been looking on the forum but I cannot find a definitive answer.

I was also wondering if someone could tell me what pulley sizes and tooth number were fitted to the stepper motors.

Hope someone can help.

Many thanks,
Oliver

[dgoadby]

I have one of these machines. I am not using the original controller as it was U/S upon arrival even though mechanics were perfect.

I will try to get the stepper motor sizes and also the pulley toothed belt information for you later this week.

David Goadby