how does tooling/chuck work on a micro router?
CNC Expert
I'm looking to purchase this machine and was after some info on it. where might I find the correct spec for it? does anyone know what setup it comes with as standard? doesn't seem to be a manual for it on here, anyone got one?
how does tooling/chuck work on a micro router?
how does tooling/chuck work on a micro router?
CNC Expert
just received the machine
are there the correct wiring diagrams around anywhere?
is this a vacuum pump at the bottom?
are there the correct wiring diagrams around anywhere?
is this a vacuum pump at the bottom?
CNC Guru
Looking at the serial plate it left the factory with VRMilling 2.11. (You can update to the latest version 2.32 from https://www.denfordata.com/downloads/VRM ... _32_CD.zip but you would need to have the licence file to run it).
The Manual can be downloaded from, viewtopic.php?f=37&t=3658
The Manual can be downloaded from, viewtopic.php?f=37&t=3658
CNC Expert
I don't have a license sadly, but thanks for the info.
is that a vacuum pump under the machine? what sort of vacuum table would work with that pump? do denford supply them?
is that a vacuum pump under the machine? what sort of vacuum table would work with that pump? do denford supply them?
CNC Guru
Yes it would have been supplied with a Trend Vacuum Bed. We now longer supply the Trend version & now fit vacuum pads to current machines.
CNC Expert
many thanks for the info.
I'm trying to iron out a few issues, are there any schematics for this machine?
when I press the green vacuum pump button on the front nothing happens, is this control by denford control board? or is that switch linked directly to the vacuum pump?
I'm not sure the door switch is working, I looked a bit knackered. why can the switch be screwed to the door? is the switch suppose to the sprung loaded?
I'm trying to iron out a few issues, are there any schematics for this machine?
when I press the green vacuum pump button on the front nothing happens, is this control by denford control board? or is that switch linked directly to the vacuum pump?
I'm not sure the door switch is working, I looked a bit knackered. why can the switch be screwed to the door? is the switch suppose to the sprung loaded?
CNC Guru
CNC Expert
many thanks for that.
I see inside the machine where the vacuum pump port comes out into the work area. inside the hole is a thread, what thread is that or what is designed to screw into that?
I see inside the machine where the vacuum pump port comes out into the work area. inside the hole is a thread, what thread is that or what is designed to screw into that?
CNC Expert
gagging for the pitch of the lead screw if anyone can help?