Hi, I am having issues connecting pc to machine (microrouter pro), I get the following error messages.
Drive reports incorrect toggle bit.????
And
Must use a setxxxlink function.????
Can anyone help and advise what to do??
Thankyou
CNC Guru
What is the colour of the 7 segment LED in the electrical panel?
If it is not red then try to connect using EasyUgrader.
If it is not red then try to connect using EasyUgrader.
CNC Expert
Hi it was green.
I have just tried the easy up grader, but still get error message
Drive reports incorrect toggle bit.....
Have I got baud rate, bit rate etc setup wrong,??
Do you know what these should be set at?
I have just tried the easy up grader, but still get error message
Drive reports incorrect toggle bit.....
Have I got baud rate, bit rate etc setup wrong,??
Do you know what these should be set at?
CNC Expert
After much investigation it would appear to be an issue with the pc, I was originally running mach3 on the system with my other router, but now I was planning to run a pro router on the same system using vr milling, a windows optimization check list I had done recommended by mach clearly has issues with other programmes.