Switched on the Denford Cyclone this morning when I went to send the turret to the home position it caused the following alarm to be displayed
520 overtravel : +Z
It's never done this before. Can anyone help?
CNC Guru
Try powering up the control while holding P & CAN at the same time.
viewtopic.php?f=47&t=2444&p=8832&hilit= ... ncel#p8832
viewtopic.php?f=47&t=2444&p=8832&hilit= ... ncel#p8832
Martin wrote:Try powering up the control while holding P & CAN at the same time.
viewtopic.php?f=47&t=2444&p=8832&hilit= ... ncel#p8832
It worked!!!
Thanks very much, a weight of my mind.