Starmill ATC - security key not connected

jai · Post by **jai** » Wed 10 Jul , 2013 22:11 pm

Machine is circa 1990. Runs on DOS. Starmill.EXE starts on boot.

Errors out with "Security Key not Connected"

Dont think this is a physical key.

Any help will be appreciated. I eventually want to upgrade to VR Milling also run the software from another machine - say XP. Have been reading lots of posts here (forum is very helpful), but not sure whether this entails hardware upgrade as well.

Thanks.

Jai

jai · Post by **jai** » Mon 15 Jul , 2013 21:11 pm

ok. got this to work. there were some issues with the location of the opt file.

andy_con · Post by **andy_con** » Wed 17 Jul , 2013 22:49 pm

starmill with atc... nice, got any pics?

jai · Post by **jai** » Thu 18 Jul , 2013 18:32 pm

you can find the photos here
viewtopic.php?f=45&t=4241&p=16722#p16722

Denford Software & Machines

Denford Software & Machines

Starmill ATC - security key not connected

Starmill ATC - security key not connected

Re: Starmill ATC - security key not connected

Re: Starmill ATC - security key not connected

Re: Starmill ATC - security key not connected