Hi
got the nova mill connected up to a computer selected machine installed baldor usb stuff
computer recognizes machine spindle will run but machine wont allow me to jog as feed rate set to zero also spindle set to 50% the machine I have doesn't have over ride potentiometers and on the hand pic on the dials in control panel there is a red cross??
the machine homes fine
any ideas please?
regards
Alan
got that one sorted.
machine parameters uncheck the potentiometer boxes.
all I need now is a crash course in fanuc.
any ideas?
machine parameters uncheck the potentiometer boxes.
all I need now is a crash course in fanuc.
any ideas?
Site Admin
The help in VR Milling is pretty good (press F1)
And also as a .pdf here: viewtopic.php?f=2&t=3152
And also as a .pdf here: viewtopic.php?f=2&t=3152