Cyclone Tool Turret Drill Holder

[cdmodelz]

Hi.

I am looking for the dimensions/hole locations of the drill/boring bar holder block used on the Cyclone tool changer turret.

I need to make a few up.

Thanks

[Denford Admin]

Do you know the make ?
Is it a Baruffaldi ?
Maybe the blocks were all the same but the chap who can find any drawings we have is away at the moment.
Post a photo so we can be sure what we're looking for.

[cdmodelz]

Hi.

Yes the turret is a Baruffaldi. Dims for the rectangular blocks used to hold sleeves for drilling/boring etc.

Thanks

[cdmodelz]

Picture attached. Dims for the blocks attached to face plate.

[angel-tech]

that face plate has all the tool clamps missing as well as the drill blocks. Except tool position 3 which has a drill block fitted, possibly.

[Denford Admin]

Hi, this could be it, as it appears to be the same as the Denford own brand turret.

[cdmodelz]

Looks good thanks. Looks like the bore is finish machined after being attached to the lathe. Not sure how? (Reamer?)

One other question. How many turrets had coolant through turret

[Denford Admin]

How many turrets had coolant through turret

Sorry, we don't know. Not sure about the finish boring either...probably drilled and reamed in situ.

[Steve]

it would probably be a variable boring bar fitted in the chuck of the machine.

The X axis would be moved to to predeturmined centre line then the final skim is taken with the boring bar.

Similar to the attached link

https://www.renukatools.in/adjustable_diam.html