CYCLONE POWER SUPPLY AGAIN.

g-speed · Post by **g-speed** » Thu 09 Nov , 2006 18:08 pm

Does anyone have a manual and wiring diagram for a Denford cyclone with a seperate power supply (see earlier question) and fanuc control.

Steve · Post by **Steve** » Thu 09 Nov , 2006 18:49 pm

Please can you supply the serial number of the machine and the date supplied?

g-speed · Post by **g-speed** » Fri 10 Nov , 2006 12:54 pm

serial number CY02020E Year of manufacture 1990

Post by **Denford Admin** » Mon 13 Nov , 2006 21:17 pm

Have a look at these.....

(If you don't have anything that opens DWG, then try QuickCAM 2D - the Demo version will import DWG and DXF, but not let you print)

I presume being 1990, that its an OTA control ? These dwgs are a bit later than that, but should be quite close.

g-speed · Post by **g-speed** » Tue 14 Nov , 2006 17:45 pm

The machine is fitted with fanuc 21i-TA control

Post by **Denford Admin** » Tue 14 Nov , 2006 18:05 pm

If its a 21i, then it can't be a 1990 machine

Here are the drawings anyway..

g-speed · Post by **g-speed** » Thu 16 Nov , 2006 0:29 am

Had another look at machine. On the id plate for the lathe it has a serial number for the the electrical system. This being 9023675.

Information