This is a program for the Turn 270 to produce a small pot with screw top lid.
For this I used a 50mm long, 25mm diameter aluminium bar.
Attachments:
- Picture of the pots
- Screw Top Pot.png (1.02 MiB) Viewed 23728 times
- 18mm fine thread fixture_male.fnl
- This fixture enables you to face off the pot and clean up the pip left from parting off.
- (2.9 KiB) Downloaded 1483 times
- 18mm fine thread fixture_female.fnl
- This fixture enables you to face off the lid and clean up the pip left from parting off.
- (2.37 KiB) Downloaded 1558 times
- NewLid_Pot.fnl
- This file contains both lid and pot together and will turn both parts in one program.
- (6.5 KiB) Downloaded 1550 times
- NewPot.fnl
- The pot
- (3.09 KiB) Downloaded 1485 times
- NewLid.fnl
- The lid
- (3.45 KiB) Downloaded 1501 times