Hi
I'm a newbie on the forum, i need to copy the offsets configuration off a laptop and on to other pc's so when VR Milling is loaded the files are already in place
Where do i find these files
Thanks
Site Admin
Is it VR Milling v2.xx or v5.xx ?
These posts may help anyway:
viewtopic.php?f=2&t=166
viewtopic.php?f=1&t=2970
In VRMilling2 they are probably stored in the files windmill.mol and windmill.mtd - you can open them in notepad to see if the numbers match the software.
These posts may help anyway:
viewtopic.php?f=2&t=166
viewtopic.php?f=1&t=2970
In VRMilling2 they are probably stored in the files windmill.mol and windmill.mtd - you can open them in notepad to see if the numbers match the software.
Its V5 and yes i think one of them post will help
many thanks
many thanks
CNC Guru
There is a far simpler solution.
In the software that has the offsets with the offset window open and active go to the Offset/Tooling menu at the top of the screen.
Select advanced.
Go to the menu again and you can save the alloffsets.MOF file to any location (say a memory stick).
Then open the new PC, open the offset window and then the Offset/Tooling menu again. Now again select advanced the select Load all and browse for the offset file on the memory stick and all should then work!
In the software that has the offsets with the offset window open and active go to the Offset/Tooling menu at the top of the screen.
Select advanced.
Go to the menu again and you can save the alloffsets.MOF file to any location (say a memory stick).
Then open the new PC, open the offset window and then the Offset/Tooling menu again. Now again select advanced the select Load all and browse for the offset file on the memory stick and all should then work!