Hi I have updated my triac with later steppers/drivers also mach 3.
The machine has the servo type spindle motor,
I would like to control it passively with just a switch and a pot for now,how do I do that?
is there any electronics schematics available?
cheers
tony
not sure havnt pulled the tray out yet only got the machine yesterday ill post back later with the details.
for now serial number tr14039f built may 89
Tony
for now serial number tr14039f built may 89
Tony
Ok found the manual it all looks straight forward,hope it works,as i havnt put power to it yet.
if not Ive got a eurotherm 508 that should do the job.
is there any market for all the original triac electronics? as im mach3ing this with new steppers and drivers?
Tony
if not Ive got a eurotherm 508 that should do the job.
is there any market for all the original triac electronics? as im mach3ing this with new steppers and drivers?
Tony
CNC Guru
i may be interested in the drivers and psu, and the steppers.
CNC Guru
stepper drivers, steppers, stepper power supply. Which stepper drivers are they, sd2/3 i expect.
ive got 3 drives and the xand y steppers no z stepper
steppers are mae? I assume it all works when you power up the base the screen comes on with no error messages?
Tony
steppers are mae? I assume it all works when you power up the base the screen comes on with no error messages?
Tony
CNC Guru
i'm off to manchester sunday, would it be possible to pop in on the way home.
sure,but to be honest id rather you take the lot with you,ie the tray with everything minus the motor controller,which works!!
make me an offer i cant refuse! as it will save me ebaying it all can you pm me?
tony
make me an offer i cant refuse! as it will save me ebaying it all can you pm me?
tony
CNC Guru
i'm happy to take the whole lot minus the inverter..
I'll pm you my number so we can have a chat.
I'll pm you my number so we can have a chat.