Dear all,
I have recently completed the conversion of my Triac to Mach 3 and have most of the original electronic boards surplus. I'm happy to sell as job lot or individually.
The following parts are for sale:
1) Metal tray with front panel (including keypad, mini CRT monitor, tape player, and mini tape player)
2) All X, Y and Z stepper drivers with an interface board.
3) Motherboard (possibly faulty - please see comments below)
4) Invertor (may be faulty - please see comments below)
Before the machine was converted, it ran perfectly for a year until it had a random spindle fault where the relays could be heard clicking but spindle didn't respond. This was never diagnosed but was most likely the invertor, can't rule out the possiblility that it was instead the spindle section of the mother board though so cannot sell this as known to be working.
I'm based in the Derby, UK. Would prefer to have components collected and will accept reduced prices for collection to save on packaging & delivery.
Attachments:
- stepper drivers and invertor
- P1040673.JPG (113.71 KiB) Viewed 5573 times
- motherboard
- P1040679.JPG (120.82 KiB) Viewed 5573 times
- Front control panel and display
- P1040678.JPG (122.78 KiB) Viewed 5573 times
The stepper driver boards have now been sold.
The other equipment is still available for sale.
Please get in touch soon if you have any interest in any of the rest of these parts.
I've got to clear out as much space as possible for a house move so would much rather they went to a good home that just have to chuck them in the bin.
The other equipment is still available for sale.
Please get in touch soon if you have any interest in any of the rest of these parts.
I've got to clear out as much space as possible for a house move so would much rather they went to a good home that just have to chuck them in the bin.