Hi,
Up until recently, the orac has been working fine.
Now the Input panel has stopped working.
There is no beeping when buttons are pressed.
The manual control buttons work fine as does spindle start/stop, it is just the programming part of the panel which is broken.
Anyone any ideas, or is it a case of replacing only?
Thanks
Input panel not working???
Moderators: Martin, Steve, Mr Magoo
- Denford Admin
- Site Admin
- Posts: 3642
- Joined: Fri 10 Feb , 2006 12:40 pm
- Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then. - Location: Sunny Brighouse
- Contact:
Re: Input panel not working???
These might help:
viewtopic.php?f=4&t=1700
viewtopic.php?f=47&t=2507&p=9124
I guess you need to be looking for corroded or cracked connectors or cables.
viewtopic.php?f=4&t=1700
viewtopic.php?f=47&t=2507&p=9124
I guess you need to be looking for corroded or cracked connectors or cables.
-
- CNC Apprentice
- Posts: 35
- Joined: Wed 09 Nov , 2011 17:17 pm
- Hardware/Software: Triac '87 converted to mach3
Orac '85 converted to mach3
Re: Input panel not working???
Thanks for that.
I have had a look, and there is only one wide ribbon cable coming from inside the touch panel to a connector on a board attached to the back of the panel itself.
The connections look good at the board end, is there any way to strip the touch panel membrane to check that end?
Thanks
I have had a look, and there is only one wide ribbon cable coming from inside the touch panel to a connector on a board attached to the back of the panel itself.
The connections look good at the board end, is there any way to strip the touch panel membrane to check that end?
Thanks
- Denford Admin
- Site Admin
- Posts: 3642
- Joined: Fri 10 Feb , 2006 12:40 pm
- Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then. - Location: Sunny Brighouse
- Contact:
Re: Input panel not working???
Membranes are usually just glued on to the circuit board.
It probably is corrosion but taking it apart to clean, could well make it difficult to get back together
It probably is corrosion but taking it apart to clean, could well make it difficult to get back together