Easiturn 3 display/monitor -adjust brightness

techy · Sat 05 May , 2012 21:24 pm

Hi
Anyone out there know how to adjust ( increase ) the brightness of the display

Thanks in anticipation

Martin · Sun 06 May , 2012 15:12 pm

If it is the internal monitor in the control panel remove the cover & adjust the Brightness pot on the card directly below the tube. If I remember correctly if you power up & press X then it shoiuld display a full screnn of X's which should make it easier.

techy · Mon 07 May , 2012 11:38 am

Thanks Martin for the quick response, will try next week when the m/c is not being used

All the Best
techy

techy · Tue 08 May , 2012 18:53 pm

Tried it today and it worked fine, you were right about the screen full of 'Xs'

Thanks again

Information