Easy Change tool holders

JohnHaine · Tue 06 Dec , 2011 23:48 pm

Does anyone have dimensioned drawings for the spindle fitting end of Easy Change toolholders please?

John.

Steve · Thu 22 Dec , 2011 14:35 pm

Try Coventry Toolholders site for the info.

https://www.coventrytoolholders.co.uk/pr ... change.htm

JohnHaine · Thu 22 Dec , 2011 16:09 pm

Thanks - as they don't give dimensions they are obviously potentially easy to make!

angel-tech · Thu 22 Dec , 2011 19:01 pm

the critical dimensions are going to be the taper diameter and the rear face of the groove.

y_shalom · Fri 30 Dec , 2011 12:18 pm

I think this holder is the same

not sure...

https://www.homemetalshopclub.org/news/1 ... &view=fitH

JohnHaine · Fri 30 Dec , 2011 14:10 pm

That looks like the one! Well spotted, and thanks. John.

angel-tech · Fri 30 Dec , 2011 14:27 pm

really usefull, thanks

flyingmike · Fri 30 Dec , 2011 22:46 pm

You can buy these from J&L if you get stuck and if you look out for the discounts you can save a few bob. I think the easy change system is great but takes up a lot of room on an already limited head height machine. hence why I raised the column. There are some nice ISO30 collet holders about though.

Information