I have a Denford 30 day training program. It has a part 1 and part 2 book (for the students). I am missing the full part one book. Does anyone have one?
Also did this particular material have Disk's with it? My 10 day training has several disk's with it. Not sure if the 30 day one is software driven, or strictly book work. Thank you
Site Admin
Are you in the USA ?
Is this milling or turning ? Which software is it based around eg, Millcam and VR Milling v2? or QuickCAM and VRMilling 5 ?
We may be able to resupply by emailing a .pdf
Is this milling or turning ? Which software is it based around eg, Millcam and VR Milling v2? or QuickCAM and VRMilling 5 ?
We may be able to resupply by emailing a .pdf
I am in the USA.
This is for Milling. We have a Micromill 2000. I am using VR 2.3.something to run the machine.
Looking for something to keep the students busy for a bit longer till I get my act together.
I am missing the full part 1 manual (the one the students use). I have the full Part 2 and the instructors manual for both.
This is for Milling. We have a Micromill 2000. I am using VR 2.3.something to run the machine.
Looking for something to keep the students busy for a bit longer till I get my act together.
I am missing the full part 1 manual (the one the students use). I have the full Part 2 and the instructors manual for both.
Site Admin
Jeff,
I've tried to reply to your recent email, but they are being rejected:
I've tried to reply to your recent email, but they are being rejected:
The destination server for this recipient could not be found in Domain Name Service (DNS). Please verify the email address and retry. If that fails, contact your administrator.