Easiturn 3 display/monitor -adjust brightness

Information and questions about Denford CNC Control electronics, general electrical issues, cables, diagrams, stepper motors, drives etc...

Moderators: Martin, Steve, Mr Magoo

Post Reply
techy
Posts: 30
Joined: Mon 12 May , 2008 14:00 pm

Easiturn 3 display/monitor -adjust brightness

Post by techy » Sat 05 May , 2012 21:24 pm

Hi
Anyone out there know how to adjust ( increase ) the brightness of the display

Thanks in anticipation

Martin
CNC Guru
CNC Guru
Posts: 1906
Joined: Fri 24 Feb , 2006 17:09 pm
Location: Brighouse

Re: Easiturn 3 display/monitor

Post by Martin » Sun 06 May , 2012 15:12 pm

If it is the internal monitor in the control panel remove the cover & adjust the Brightness pot on the card directly below the tube. If I remember correctly if you power up & press X then it shoiuld display a full screnn of X's which should make it easier.

techy
Posts: 30
Joined: Mon 12 May , 2008 14:00 pm

Re: Easiturn 3 display/monitor

Post by techy » Mon 07 May , 2012 11:38 am

Thanks Martin for the quick response, will try next week when the m/c is not being used

All the Best
techy

techy
Posts: 30
Joined: Mon 12 May , 2008 14:00 pm

Re: Easiturn 3 display/monitor

Post by techy » Tue 08 May , 2012 18:53 pm

Tried it today and it worked fine, you were right about the screen full of 'Xs'

Thanks again

Post Reply