nova mill problems

All info relating to the Denford Novamill CNC Milling machines

Moderators: Martin, Steve, Mr Magoo

Post Reply
Alan W notts
Posts: 8
Joined: Tue 21 May , 2013 22:14 pm
Hardware/Software: just purchased novamill software none 2.95 on machine label

nova mill problems

Post by Alan W notts » Sat 01 Jun , 2013 12:39 pm

Hi
got the nova mill connected up to a computer selected machine installed baldor usb stuff
computer recognizes machine spindle will run but machine wont allow me to jog as feed rate set to zero also spindle set to 50% the machine I have doesn't have over ride potentiometers and on the hand pic on the dials in control panel there is a red cross??
the machine homes fine
any ideas please?
regards
Alan

Alan W notts
Posts: 8
Joined: Tue 21 May , 2013 22:14 pm
Hardware/Software: just purchased novamill software none 2.95 on machine label

Re: nova mill problems

Post by Alan W notts » Sat 01 Jun , 2013 22:58 pm

got that one sorted.
machine parameters uncheck the potentiometer boxes.
all I need now is a crash course in fanuc.
any ideas?

User avatar
Denford Admin
Site Admin
Posts: 3642
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:

Re: nova mill problems

Post by Denford Admin » Mon 03 Jun , 2013 11:13 am

The help in VR Milling is pretty good (press F1)
And also as a .pdf here: viewtopic.php?f=2&t=3152

Post Reply