Z+ overtravel

All info relating to the Denford Cyclone lathes

Moderators: Martin, Steve, Mr Magoo

Post Reply
Dave King
Posts: 5
Joined: Wed 06 Apr , 2011 8:39 am

Z+ overtravel

Post by Dave King » Tue 20 Aug , 2013 13:22 pm

Switched on the Denford Cyclone this morning when I went to send the turret to the home position it caused the following alarm to be displayed
520 overtravel : +Z

It's never done this before. Can anyone help?
Top
Martin
CNC Guru
CNC Guru
Posts: 1901
Joined: Fri 24 Feb , 2006 17:09 pm
Location: Brighouse

Re: Z+ overtravel

Post by Martin » Tue 20 Aug , 2013 14:21 pm

Try powering up the control while holding P & CAN at the same time.

viewtopic.php?f=47&t=2444&p=8832&hilit= ... ncel#p8832
Top
Dave King
Posts: 5
Joined: Wed 06 Apr , 2011 8:39 am

Re: Z+ overtravel

Post by Dave King » Tue 20 Aug , 2013 17:05 pm

Martin wrote:Try powering up the control while holding P & CAN at the same time.

viewtopic.php?f=47&t=2444&p=8832&hilit= ... ncel#p8832

It worked!!!

Thanks very much, a weight of my mind.
Top
Post Reply

Return to “Cyclone”