Hi, i have bought a Cyclone. i am after some initial basic information about wiring up (there will be more to follow)?
The machine details are as follows:-
Serial number :-50911D
Dispatch date :- October 1995
Electrics Serial number:- OC0015002
Software version 1.34
I seems to be in near perfect original condition. So assuming untampered with.
There is a single armoured cable coming out of the machine containing a Yellow/Green, Brown, Blue and 2 black wires. Question. Is the machine fitted with a 3 phase inverter or do I need to provide the 3 phase supply?
Denford Cyclone Wiring
Moderators: Martin, Steve, Mr Magoo
-
Denford Admin
- Site Admin
- Posts: 3636
- Joined: Fri 10 Feb , 2006 12:40 pm
- Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then. - Location: Sunny Brighouse
- Contact:
Re: Denford Cyclone Wiring
Here is the original electrical inspection sheet.
It was 3 phase originally but someone may have fitted a single phase > 3 phase converter...you'll have to follow the mains wires.
It was 3 phase originally but someone may have fitted a single phase > 3 phase converter...you'll have to follow the mains wires.
- Attachments
-
- 50911D.pdf
- (32.78 KiB) Downloaded 1042 times
-
makman
- Posts: 8
- Joined: Tue 01 Jan , 2013 8:44 am
- Hardware/Software: denford Triac (easicnc), Denford Cyclone (tutor)
Re: Denford Cyclone Wiring
I am being told that i will need the original machine set up. Datum parameters due to the time the machine has been disconnected. Is this the case?
Re: Denford Cyclone Wiring
The datum parameters are somthing you can set once the machine is running. Is the computer attached to the machine still working?