Search found 82 matches

2000 TRIAC PC FOR SALE ON EBAY ITEM NO. 140353303538


excellent condition. comes with laptop and vr milling 2.3 plus loads more tools etc...

its the x axis. backlash is fine. would not tightening the gib strip increase the chance of stalling?? extra stress on motor?? how do i know which is the z drive. my electrical is skill is minimal. how do i check the current?

feedrate max is 1000 but this program is cutting at 150- rapid 1000 ...

picture shows the engraving done with turbo and without - machining the same program notice the difference! i dont think its the gibs or motor sticking- checked the gibs and belt tension. its so closely machined and it still happens. think it must be software???? the euro card and axis drive were ...

the Shortest Contour is set at 0. eprom is mint 2.1. cant understand why its fine when not using turbo. even in simple bigger moves it loses posistion. the battery in my eurostep card has been removed due to corrosion could this be the answer- no damage was done to the card though. will post pic ...

already using that version - no difference.

when i run an engraving program with turbo mode activated posistion of the letters are not in line. running the same program with turbo mode deactivated its fine??? why?? what can i do to make it run under turbo mode and still get the accuracy??


any help would be much appreciated. thanks.

is it possible to reduce the slight dwell between programm lines while machining? i am using vr milling 2.3 on a triac pc (2000)

ANYONE WHO HAS A GOOD WORKING POST PROCESSOR FOR DELCAM FEATURECAM I WOULD BE GRATEFUL IF THEY COULD POST IT.

MANY THANKS.

need all electrical drawings available.

thanks..

i have checked the cards are seated and ribbon cables are attached properly. i have swapped over the wires to the y axis with the x. the x then works fine. so its not the card as i have swapped the Y axis card with the x and it still does not work, its not the motor, its not the pcb board as i have ...

anything considered

WHY IS IT NEEDED AND WILL THE MACHINE FUNCTION WITHOUT IT?

WHERE CAN I GET A REPLACEMENT AS MINE HAS LEEKED?

i just fool the machine into thinkin its datumed it does not actually move.

the motor does not turn- checked the fuses- on card and main board. no problem- even swapped the axis card with one i know works- still nothing.

vr milling shows it moving in x axis but it does not.

dont know how to ...

i can activate and datum it manualy but get no movement at all from the x axis. i am using Vr milling 2.3

the x axis is not working- tried changing the axis control card- no diffferent. when checking the x datum switches notice 2 blue wires appear to have been cut by the previous owner(note pic) could this be the problem? also i have had to remove the battery from the eurostep controller card as it was ...

looking for control boards, axis drives, emergency stop switch, rs232 cable, eurostep controller etc.

please let me know what you have.

mant thanks.

how much do you want? it is old software dont know why its not free.

need registration key. will buy

if you want to sell, please let me know.