Page 1 of 1
Triac at work video
Posted: Mon 22 Jan , 2007 22:12 pm
by Triac whizz
Just for giggles I've uploaded a video of my Triac hammering a 18mm U drill through ali at 3500rpm and 200mm/min, the vid goes on and shows the whole job, there's no interval for popcorn & ice cream I'm afraid
https://video.google.co.uk/videoplay?doc ... 7361361204
broadband recomended
Posted: Tue 23 Jan , 2007 16:15 pm
by davidimurray
Nice video.
Is that a stepper or a servo machine? Original controls or a retrofit?
When I get a min will post some vids of the starturn at work.
Cheers
Dave
Posted: Fri 26 Jan , 2007 11:18 am
by Triac whizz
Fanuc controls - out of the box as it left Denfords, give or take a few parameter changes
Posted: Fri 26 Jan , 2007 11:54 am
by Denford Admin
Nice - what is it ?
btw - no guards on your machine ?
Posted: Fri 26 Jan , 2007 12:29 pm
by Triac whizz
It's a bearing block see
viewtopic.php?t=342 the thingys on the right
Guarding? It's all there - for what its worth but it was down for the video and I can't put it right up when I have a vice on the table - and wellies are obligatory when using suds! Is there something missing then? perhaps a cagoule?
