Alphacam post for Denford Cyclone

[Bolan41]

Hi all does anyone know if there is a Alphacam post for for a Cyclone lathe. I have just purchased this machine so all a bit new to me mostly ese cnc routers. Thanks

[rasp]

The Fanuc 15,18 or 21 post should work fine.

[Bolan41]

Hi thanks for the reply, what about the 6Tpost would that work?

[rasp]

I will work as long as you do not use the canned cycles in Alphacam, The 6T post is single line canned cycles, the 0i,15 18i and 21i are all 2 line canned cycles unless you have the F15 option installed in the control.