Hi All
Please be gentle its my first time here, I have a Viceroy TDS Lathe, and i am replacing the variator that was fitted, but i have allways had a slight runout when turning a straight peice of metal, i have notice four large nuts above the motor holding the haed stock assy and presume these are for adjusting the head stock??, can any one give me advise on how to adjust run out.
Thanks
Roy
CNC Guru
You may be better posting this in the Viceroy page on the forum.
Have you looked on that page?
https://www.denfordata.com/bb/viewforum.php?f=50
Have you looked on that page?
https://www.denfordata.com/bb/viewforum.php?f=50