Tool holders

[Arclaser]

I am very new to Cnc lathes , and dont know to much about them.
I purchase a old Denford Cyclone Cnc lathe a cpl months ago.And managed to run a few basic parts of now , even if i do say so my self there not to bad.
Now i am looking for some of the block tool holders to fit drills , boring bar in. They have 4 bolt holes and a 25.4mm bore.
Sorry i dont know the correct part number/ name for them.
Denford do not sell them, anyone know where i can purchase a 2 of 3 of them

Ron

[jamesgates1000]

Hi, I just made a load of these for my cyclone. They are rough bored to 22mm the idea being they get bored true in the turret. You can buy a couple of these off me if you like, or you can have the two I already had which are bored to 25mm. James