Denford Cyclone

[philog4559]

Hi I am after an auto tool changer for a Denford Cyclone Lathe. I would also like to get in touch with anyone who considers themselves qualified to offer help, advice and/or maintainence on the Cyclone. I am willing to pay for the correct help and any support would be greatly appreciated.

Phil

[Martin]

What control system does your Cyclone have Phil?

[philog4559]

Hi Martin

The machine uses a Fanuc control system.

[philog4559]

Hi Martin

Sorry about my lack of knowledge with this machine, but having looked through the forum and read some of the posts, the machine is controlled from a floppy disk using a DOS based software. Hope this helps a little.

Regards

Phil