North East Electronics SMCU installation and maintenance guide
NEE SMCU Installation Guide Version2 Oct 1987 OCR pdf
CNC Guru
Love the minimum system requirements:
"DOS 2.0 or higher"
All of the old Denford applications used a customised version of the SMCU controller firmware (for things like the SMCU controlled Starmills and the Triacs "ATC Controller board") but the hardware should be pretty much the same as this doc.
"DOS 2.0 or higher"
All of the old Denford applications used a customised version of the SMCU controller firmware (for things like the SMCU controlled Starmills and the Triacs "ATC Controller board") but the hardware should be pretty much the same as this doc.