Easimill 3 electrical schematic drawing wanted

[snadeau]

I need the electrical schematic drawing of a Easimill 3

Model TDS/E/M/CNC

serial EO 2566

and if you have any information about the stepper motor.(voltage,amp,etc)

thanks

[Denford Admin]

Have you seen these ?

viewtopic.php?t=1619
viewtopic.php?t=1164
viewtopic.php?t=196

[snadeau]

Yes but on the first on i didn't see any link to download it.
and in the second that was only a maintenace manual.
and in the third that was software.

we want replace the controler and drive.

we want use the actual step motor.

thank to help me, i appeciate

[Denford Admin]

Yes but on the first on i didn't see any link to download it.

You must be logged in to see the download links (if not, then it could be a browser issue)

and in the second that was only a maintenace manual.

The maintenance manual has a spec sheet at the end that states:
Stepper motors ... 200 Steps/Rev, 3.5 Amps, 1.1 Ohms

There is a wealth of information here and on other forums for what you are wanting to do, however, you really need to sift through it all to get everything you need. No-one will have all the answers.

[snadeau]

thank a lot