thanks alot! complete rip off..
CNC Apprentice
cant seem to find the correct combo even tho i spent hours going through one by one.. NEE want to charge me £195 plus vat before they will even consider helping me for a basic support contract and wont supply a manual to the electrical board for less than £100 plus vat..!!!!
thanks alot! complete rip off..
thanks alot! complete rip off..
Site Admin
It looks like Denford never had much to do with this board, so NEE will be your last chance.
I reckon £100 is a fair price for a manual of this vintage -
You've got to consider that someone with better things to do, will have to go searching through the archives, photocopy the (possibly) only copy of the manual, and ship it out to you.
I reckon your only other alternative would be to make your own control logic on a PIC chip or similar and patch it into the tool stepper drive (I take it this board controlled the carousel indexing stepper and the solenoid valves ?)
I'll take another look round work tomorrow anyway
I reckon £100 is a fair price for a manual of this vintage -
You've got to consider that someone with better things to do, will have to go searching through the archives, photocopy the (possibly) only copy of the manual, and ship it out to you.
I reckon your only other alternative would be to make your own control logic on a PIC chip or similar and patch it into the tool stepper drive (I take it this board controlled the carousel indexing stepper and the solenoid valves ?)
I'll take another look round work tomorrow anyway
CNC Expert
Pab - sounds like your having a bit of a nightmare.
Unfortunately none of the diagrams I've seen have any info on the toolchanger. Have you tried running the diagnostic tets in the maintenance manual I posted a while back - just in case it is something else.
Have you tried CNCzone or perhaps one of the Mach3 forums asking for info. Might find some other owners.
Good luck with you search - I will see if I can find anything but I don't hold out much hope.
Cheers
Dave
Unfortunately none of the diagrams I've seen have any info on the toolchanger. Have you tried running the diagnostic tets in the maintenance manual I posted a while back - just in case it is something else.
Have you tried CNCzone or perhaps one of the Mach3 forums asking for info. Might find some other owners.
Good luck with you search - I will see if I can find anything but I don't hold out much hope.
Cheers
Dave