Can you set different origins in terms of where the laser starts without moving the object/drawing in the original laserCam software. Currently I can only get it starting from the lower left corner
Site Admin
Recent question from a customer using LaserCAM 2D with a versalaser laser cutter:
Site Admin
If you notice when you go to the print preview in LaserCAM, there are two boxes called offset (mm) X and Y.
Setting these values will offset the print output, but not alter the original drawing
See this image...
Setting these values will offset the print output, but not alter the original drawing
See this image...
Attachments:
- Offset the print output in LaserCAM and QuickCAM
- lasercam-offset-printing.gif (23.56 KiB) Viewed 6238 times