Router 2600 Pro (sold)

[Graham S]

Sold, delete thread if you wish.

[Graham S]

FYI I am currently sorting out some photos of the machine, I'm having to move half the workshop before hand though but should get them done today.

Graham

[Graham S]

Here are some images of the machine, I've made notes on each.

Also note I will replace the polycarbonate door with a new one so there will be no scratches. I will also get hold of proper spanners for the spindle, one is a standard spanner and the other a special one. I'll basically make sure you get a great machine ready to go.

Cheers,

Graham

This is the machine on the bench, I have noticed the door has picked up scratches, I will order some polycarbonate and make a replacement. The only other marks on the whole machine are tiny bits of hangar rash on the edges of the cabinet, very subtle.

overview.JPG (48.49 KiB) Viewed 5995 times

Inside the machine, it powers and runs perfectly

inside.JPG (53.54 KiB) Viewed 5995 times

The various bits with it (plus some documentation) the collets are ER20 not ER32 as I stated originally.

bits n bobs.JPG (67.16 KiB) Viewed 5995 times

This is a neat little cam based sheet clamp with t-nuts

clamp.JPG (43.42 KiB) Viewed 5995 times

1.2KW Fimec spindle

spindle.JPG (45.09 KiB) Viewed 5995 times

Just to prove it can move from the home position, perhaps not obvious.

machine moved.JPG (42.62 KiB) Viewed 5995 times

Power and USB connection.

end.JPG (44.76 KiB) Viewed 5995 times

This has vents for venting out dust, there are similar holes in the other end of the machine in the bottom, if not used could easily be blanked off with some sheet or even ali tape.

totherend.JPG (50.47 KiB) Viewed 5995 times

This allows you to connect an extractor, 4" hose fitting I think.

extraction.JPG (47.24 KiB) Viewed 5995 times

[Graham S]

Please note, what looks like a blotch on the front of the lower edge of the machine in the first image is actually dust on my phone's camera sensor, you can also see it on the close up of the software.

Graham