Hi,
I have decided to install a new control system in my Easimill and have very carefully removed a number of original parts from the machine thinking that other owners might be interested in getting hold of some spares? For simplicity I have listed the parts on Ebay, search for Denford.
I have listed the Digiplan stepper drivers, the screen, the PNC3 Interface card and the Processor keyboard card including VDU board.
At the time I started dismantling everything was working and I have been very carefull so I would expect the parts to be in good shape.
Hope that this gives someone some help.
Ian
PS I also have a brand new casette tape just bought (at great expense!) from North East Electronics if anone is interested.
Replying in the hope you might still have the display from your Easimill re-fit, would it be compatible with an Easimill 3.
Are you still holding spares for a PNC3, if so could you let us know, thanks.
Hi,
Just dropped back into the forum for a look around and spotted your post. Unfortunately the Denford spares went one way or another quite a while ago.
Sorry
Ian
Just dropped back into the forum for a look around and spotted your post. Unfortunately the Denford spares went one way or another quite a while ago.
Sorry
Ian
Ian