All the info documentation and schematics that came with a 1988 Starturn8
Starturn8-electrical-schematic.pdf
Starturn8-Parts-List.pdf
Starturn-IBM-Software-Manual.pdf
CAM-Designer-Software-Manual.pdf
Starturn-8-Parts-Manual.pdf
STARTURN-PROGRAMMING-OPERATIONS-MANUAL.pdf
Starturn-Programming-Examples.pdf
Site Admin
Posts: 3651
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:
Site Admin
Site Admin
Posts: 3651
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:
Site Admin
This 1988 machine had Parker SD3 drives, GSM control an SEM DC servo spindle motor and JAY Electronics spindle drive.
(If anyone has any info on the spindle drive I'd appreciate it)
(If anyone has any info on the spindle drive I'd appreciate it)